Ryobi RTS11 Manual Del Operador página 27

TO USE THE RIP FENCE
See Figure 28.
WARNING:
To reduce the risk of injury, always make sure the rip fence
is parallel to the blade before beginning any operation.
 Loosen the rip fence by lifting the locking lever.
 Place the rear lip on the rear of the saw table and pull
slightly toward the front of the unit.
 Lower the front end of the rip fence onto the guide
surfaces on top of the front rail.
 Check for smooth gliding action.
 Position the rip fence the desired distance from the blade.
 With the rip fence flat on the saw table, push the fence
towards the front rail to align the fence to the saw table.
 Push the locking lever down to align and secure the
fence. When securely locked, the locking lever should
point downward.
Ensure the locking lever secures the rip fence in place. If
adjustments are needed, see To Check The Tightness Of
The Rip Fence Locking Lever in the Adjustment section
of this manual.
TO SET THE RIP FENCE SCALE INDICATOR
TO THE BLADE
See Figure 29.
Use the indicator on the rip fence to position the fence along
the scale on the front rail.
NOTE: The blade guard must be removed to perform this
adjustment. Reinstall the blade guard when the adjustment
is complete.
Begin with the blade at a zero angle (straight up).
 Unplug the saw.
 Loosen the rip fence by lifting the locking lever.
 Using a framing square, set the rip fence 2 in. from the
blade tip edge.
 Loosen the screw on the scale indicator and align with
the 2 in. mark as shown.
 Tighten the screw and check the dimension and the rip
fence.
OPERATION
RIP
FENCE
FRONT
RAIL
BLADE
27 - English
SCALE
INDICATOR
RIP
FENCE
2 in.
LOCKING
LEVER
LOCKING
LEVER
REAR
LIP
Fig. 28
2 in.
MARK
SCREW
SCALE
FRONT
RAIL
Fig. 29