Sennheiser freePORT Instrucciones De Uso página 19

freeport.book Seite 19 Mittwoch, 18. Mai 2005 8:35 08
Connecting the receiver
Insert the DC connector on the mains cable into the DC socket
connect it to the mains. The green LED for operation indication
·
(POWER) lights up and the receiver is ready for operation.
To deactivate the receiver, remove the mains plug from the mains
outlet.
Aligning the antennas
Set up the antennas and align them upwards in a V-shape.
The LEDs A and B
antenna) is active.
Connecting the amplifier/mixing console
Connect the amplifier/mixing console to the XLR-3M socket
the ¼" (6.3 mm) jack socket µ.
Use the GAIN control
input of the amplifier or mixing console. The adjusted audio output
level is common for both sockets. If the level is adjusted too high,
the audio signal will be distorted. If, on the other hand, the level is
adjusted too low, this will result in an audio signal with high
background noise.
Selecting and changing a channel
You can change the channel on the receiver during running operation.
The receiver then immediately receives on the new channel.
Use a small screwdriver to set the channel selector switch
desired channel. You can switch between four different channels
(see "Selecting a channel" on page 24).
indicate which diversity section (i.e. which
¸
to adapt the level of the audio output to the
and
¾
or
¿
to the
19