Using in a Car (for Rear
Seat Passenger)
Use the headrest mounting bracket and car
battery adaptor (both supplied) for rear seat
passengers to enjoy the player.
b
• Do not perform installation while the car is
being driven.
• The adaptor is for a 12V car battery. Do not use
it with a 24V battery.
• The adaptor is only for use with negatively
grounded cars. Do not use it with cars
grounded positively.
• Depending on the seat type, it may not be
possible to mount the player.
Mounting the player at the
back of the front seat
You should not use the battery pack in the
car. Turn off the player and remove the
battery pack in advance (page 11).
1
Attach the bracket to the headrest.
Adjust the height of the headrest to
allow approx. 3 cm of space (1).
Attach the bracket by buckling up
firmly until it clicks (2), then
securely tighten the belt (3).
12
GB
If the headrest is too high, the belt may
loosen, which could cause an accident
or injury.
2
Rotate and fold down the LCD panel
(page 9).
3
Attach the player to the bracket.
Securely hold the player with both
hands.
Engage the hooks of the bracket into
the holes on the bottom of the player.
Bracket
Slide the player in the direction of the
arrow until it clicks into place.
Bottom of the player