RIB KING EVO Manual Del Usuario página 45

After having carried out the various connections and having supplied voltage, all the LEDS are
switched OFF.
The motor opens and closes, but it has no strength and moves slowly.
The gate opens but does not close after the time set.
The gate does not open or close by activating the various START, RADIO, OPEN and CLOSE
buttons.
The electric lock does not work.
Impact sensor intervenes during the movement
The buzzer emits 2 long tones and the gate does not move
The remote control does not work. Led DL12 lit red
ACCESSORIES -
For the connections and the technical data of the optional equipments follow the relevant handbooks.
BATTERY CHARGER CARD
RADIO TRANSMITTER SUN
SUN 2CH cod. ACG6052
SUN CLONE 2CH cod. ACG6056
SUN-PRO 2CH cod. ACG6210
FAULT
code ACG4773
SUN 4CH cod. ACG6054
SUN CLONE 4CH cod. ACG6058
SUN-PRO 4CH cod. ACG6214
On the board there are resettable fuses which intervene in the event of a short circuit,
interrupting the output assigned to them.
In the event of troubleshooting, it is advisable to disconnect all the removable connectors and
insert them one at a time in order to more easily identify the cause of the fault.
Check fuses F1, F2.
If the fuse is blown, use only a suitable replacement.
F1 T 2A TRANSFORMER PROTECTION FUSE (on the outside of the B2 24V board)
F2 T 8A MOTOR PROTECTION FUSE
Check trimmers RUN and LOW SP adjustment.
Make sure that the TCA trimmer is activated with LED DL11 ON.
B.I.O. contact always on => check the status of the clock connected to B.I.O..
Photocells Auto-test failed => check the connections between the control panel and the
photocells.
Stop, Edge or Photocell with DIP 4 OFF contact fault => Fix or replace the faulty contact.
Photocells Auto-test failed => check the connections between the control panel and the
photocells.
Ensure to have enabled DIP 8 to ON.
Check the cable.
Turn the SENS trimmer clockwise
Safety edge with 8,2 KΩ resistor. Remove the resistor or configure the EDGE input via the RIB
GATE app
Lack of radio module in connector J6 or faulty radio module.
BATTERY
Battery 2,2Ah 12V
RADIO MODULE 433MHz
45
SOLUTION
code ACG9515
code ACG8069
G
B