Section
Playing songs on iPod
11
Listening to songs on your
iPod
You can use this unit to control an iPod adapter,
which is sold separately.
These are the basic steps necessary to operate
an iPod adapter. More advanced iPod adapter
operation is explained starting on Introduction
of advanced iPod adapter operation on page 70.
1 Song number indicator
Shows the number of song played in the se-
lected list.
2 Play time indicator
Shows the elapsed playing time of the cur-
rent song.
1
Press SOURCE to select the iPod.
Press SOURCE until you see iPod displayed.
2
To perform fast forward or reverse,
push and hold MULTI-CONTROL left or
right.
3
To skip back or forward to another
song, push MULTI-CONTROL left or right.
Pushing MULTI-CONTROL right skips to the
start of the next song. Pushing
MULTI-CONTROL left once skips to the start
of the current song. Pushing again will skip to
the previous song.
68
En
1 1 1 1
2 2 2
Browsing for a song
The operation of this unit to control an iPod is
designed to be as close to the operation of the
iPod as possible for easy operation and song
search.
1
Press LIST to switch to the top menu of
the list search.
2
Use MULTI-CONTROL to select a cate-
gory.
Turn to change the category; press to select.
PLAYLIST (playlists)—ARTIST (artists)—
ALBUM (albums)—SONG (songs)—GENRE
(genres)
List from the selected category is displayed.
# You can start playback throughout the se-
lected category by pressing and holding
MULTI-CONTROL.
# You can also change the category by pushing
MULTI-CONTROL up or down.
# You can also select the category by pushing
MULTI-CONTROL right.
# To return to the previous list, push
MULTI-CONTROL left.
# To go to the top menu of the list search, push
and hold MULTI-CONTROL left.
# If you do not operate the list within about 30
seconds, the list search is cancelled automati-
cally.
Searching for a song
1
Press LIST to switch to the top menu of
the list search.
2
Use MULTI-CONTROL to select a GENRE,
ARTIST, ALBUM or SONG from among the
categories.
Turn to change the category; press to select.
List from the selected category is displayed.