After Installation; Adjusting The Microphone Angle - Pioneer AVIC-Z910DAB Manual De Instalación

Double-sided tape
Clamps
Use separately sold clamps to secure
the lead where necessary inside the
vehicle.
NOTE
Install the microphone on the steering
column, keeping it away from the steering
wheel.

Adjusting the microphone angle

The microphone angle can be adjusted.
12
En

After installation

After installing this
product
1
Reconnect the negative (-) terminal of
the vehicle's battery.
First, double-check that all connections
are correct and that this product is
installed correctly. Reassemble all
vehicle components that you previously
removed. Then reconnect the negative
(-) cable to the negative (-) terminal of
the battery.
2
Start the engine.
3
Press the RESET button.
Press the RESET button on this product
with a pointed object such as the tip of
a pen.
Z910DAB Z810DAB
Z710DAB Z610BT Z7110DAB
Z6110BT
• Some of the settings and recorded
contents will not be reset.
4
Change the settings as desired.
• For details concerning operations,
refer to Operation Manual.
5
Drive down an unobstructed road
until the GPS starts receiving the
signal normally.
NOTE
After installing this product, be sure to
check at a safe place that the vehicle is
performing normally.