Console - Tunturi E30L Manual Del Usuario

CONSOLE

BUTTONS
1. SELECTION DIAL
The selection dial functions in two ways:
A) Rotating the dial (+ / -). By rotating the dial
clockwise, you can scroll the menus to the right, and
increase values or resistance. By rotating the dial
counter-clockwise, you can scroll the menus to the
left, and decrease values or resistance.
B) Pressing the dial (ENTER). By pressing the dial, you
can accept the selection you made when rotating
the dial.
2. START/STOp
Starts, pauses, and stops training. During training,
pressing this button once activates the pause mode.
Pressing the button again starts the program again.
3. RESET
Single push: return to the program menu. Long
push: restarts the meter.
4. RECOVERY
Calculates your recovery heart rate index.
5. BODY FAT
Calculates your body mass index (BMI) and shows
your body fat %.
DISpLAY
Time (mm:ss), speed (km/h or ml/h), RPM
(revolutions per min), distance (km or ml), energy
consumption (kcal), power(W) and heart rate (bpm)
are displayed.
6
pROGRAMS
1. MANUAL pROGRAM
Set target time and/or distance and/or energy
consumption and/or upper heart rate limit by using
the SELECTION DIAL.
Start training by pressing START/STOP button.
If you have set target/targets, the target/targets start
to count down. Adjust resistance with SELECTION
DIAL.
2. pRESET pROGRAMS
Preset program profile is shown for two seconds
while programs are browsed. Select desired preset
program by using the SELECTION DIAL.
Set time for training and/or target distance and/or
energy and/or upper heart rate limit by SELECTION
DIAL.
Start training by pressing START/STOP button.
If you have set target/targets, the target/targets
start to count down. During training you can scale
the load by SELECTION DIAL.
3. USER pROGRAM
The program profile used last time is displayed.
You can either start training with your personal
memorized training targets by pressing START/
STOP or modify the program. The program profile
bar (1/16) that can now be modified blinks. If
you want to change, modify the blinking bar and
confirm. Next bar will blink. After the last bar, the
display switches back to the first bar. By pressing
ENTER button for 2 seconds you can finish the
profile modifying. Now program is ready with your
memorized personal training data (time, distance,
energy targets and heart rate limit). Modify your
targets if needed. Start training by pressing START/
STOP button.
If you have set target/targets, the target/targets
start to count down. During training you can scale
the load by SELECTION DIAL
4. TARGET HR (H.R.C)
Select between four different training intensities
(55%, 75%, 90% or TARGET). By selecting TARGET
you can insert target heart rate.
Start training by pressing START/STOP button.
During the training the equipment will
automatically adjust the resistance so that your
target will be reached and maintained.
5. CONSTANT WATT
Set target power in watts and target time and/or
distance and/or energy consumption and/or upper
heart rate limit by SELECTION DIAL.
Start training by pressing START/STOP button.