Fault Indicator - ESAB Cutmaster 60 Manual De Instrucciones

5.04 Fault Indicator

At initial power up, two lights will temporarily illuminate for 2-3 seconds to show the version of software
used.
To determine the first digit, count the function indicators left to right, 1 through 5. To determine the
second digit count the pressure indicators, reading from bottom to top, 0 through 7. In the example
below the Temp indicator and 75 psi indicators are ON indicating the version would be 2.3.
!
When the "Fault" indicator is ON or blinking it will be accompanied by one of the pressure indicator lights
depending on what the Fault is. The following table explains each of those Faults.
NOTE!
Fault explanations are covered in the following tables.
300x5395
7
6
5
A
MIN MAX
PSI BAR
MAX MAX
4
3
2
1
MIN MIN
0
!
1 2 3 4 5
Pressure Fault
Indicator
Max Over Pressure
90 Internal Error
85 Check Consumables
80 Consumables Missing
75 Start Error
70 Parts in Place
65 Input Power
Min Under Pressure
SERVICE
ESAB CUTMASTER 60
+
Art# A-07988
5-3