E Codes - Snap-On EEWB333B Manual Del Operador

Code C28
Displays the error codes saved by the balancer (a
maximum of 10) and clears the error memory.
The last 10 different error codes are saved in the
error memory so that they can be called up and
consulted by the wheel balancer operator for remote
diagnosis of malfunctions.
The most recent error code is saved in memory
location 1. Previous error codes are gradually shifted
down the memory list.
- Go into code C28.
REVIEWING THE ERROR COUNTERS
- Press and release the "+" or "-" key to scroll
through the list of errors.
Note: When the key is pressed the number of the
error in the list is shown, whilst when the
key is released the corresponding code
appears.
- Press the MODE key to make the error number
appear again (on the left) and the total number
of times that error was repeated since the last
time the memory was cleared (on the right).
ZEROING THE ERROR COUNTERS
- Press ENTER.
- Make the selection.
0* = Do not clear the error memory
1 = Clear the error memory
- Press ENTER.
36
10.1.2 E-CODES
When the E-code is displayed, a low beep is generated.
Whenever a code appears:
• Write it down
• Look up the code in the list. If the code is not
described, call service.
• Perform the steps described.
The setup of this chapter is:
Code
Description
• Step(s) to be performed.
Some error messages are displayed for approx. 3
seconds on the display of the right side.
• To clear the error code immediately press the
STOP key.
E9
Optimization / minimization was not carried out correctly.
1. Wheel was not exactly centred on clamping means
for at least one run.
2. Tire was not centred on rim for at least one run.
3. Valve position was not set and acquired correctly
at least once.
4. Wrong reference mark (single or double) was used
when readjusting the tire.
5. Wheel moved on clamping means during a
measuring run (-7.1.3)
E10
SAPE arm removed from idle position during wheel spin.
• Bring SAPE arm to the idle position (fully in and down).
• Re-spin the wheel without touching the SAPE.
• If the error appears again, have the SAPE calibrated
(by the service department).
Display clears after several seconds.
E11
During start-up the SAPE arm is not in the idle position.
• Move the SAPE arm back carefully to the idle position.
The error should disappear within a few seconds.
• If the error appears again, contact the service de-
partment.
Note: By pressing STOP you can continue to use
the machine but all the wheel data must be inserted
manually (F 4.5.3).
EEWB333B