Clock And Timers - Panasonic SC-PM600 Instrucciones De Funcionamiento

Improving the sound quality
1
Press [PLAY MENU] repeatedly to select
"FM MODE".
2
Press [R, T] to select "MONO" and then press
[OK].
To cancel, select "STEREO".
"MONO" is also cancelled when you change the
frequency.
To memorise the setting
Continue with step 4 of "Manual presetting".
Checking the signal status
Press [DISPLAY] to select "FM STATUS".
FM – – – – The FM signal is in monaural.
The system is not tuned in to a station.
FM ST The FM signal is in stereo.
FM MONO "MONO" is selected as the "FM MODE".
RDS broadcasting
This system can show the text data transmitted by the
radio data system (RDS) available in some areas.
Press [DISPLAY] repeatedly.
PS Programme service
PTY Programme type
FREQ Frequency
Note:
RDS may not be available if reception is poor.
8
8

Clock and timers

Setting the clock
This is a 24-hour clock.
1
Press [SETUP] repeatedly to select "CLOCK".
2
Press [R, T] to set the time and then press [OK].
To check the time
Press [SETUP] repeatedly to select "CLOCK" and then
press [OK].
In standby mode, press [DISPLAY].
Note:
Reset the clock regularly to maintain accuracy.
Play timer
(Except for Bluetooth ® source)
You can set the timer to come on at a certain time to
wake you up.
Preparation
Set the clock.
1
Press [SETUP] repeatedly to select "TIMER ADJ".
2
Press [R, T] to set the start time and then press
[OK].
3
Do step 2 again to set the end time.
4
Press [R, T] to select the source you want to play
and then press [OK].
To start the timer
1
Press [SETUP] repeatedly to select "TIMER SET".
2
Press [R, T] to select "SET" and then press [OK].
"#" is shown.
To cancel, select "OFF".
The system must be switched off for the timer to
operate.
To check the setting
Press [SETUP] repeatedly to select "TIMER ADJ" and
then press [OK].
In standby mode, press [DISPLAY] two times.
Note:
• The timer starts at a low volume and increases gradually to
the preset level.
• The timer comes on at the set time every day if the timer is
on.
• If you switch off the system and then switch on again while
a timer is in operation, the timer will not stop at the end
time.