Clock And Timers; Sound And Illumination Effects - Panasonic SC-MAX200 Instrucciones De Funcionamiento

Radio
Manual tuning
1
Press [RADIO/EXT-IN] to select "FM" or "AM".
2
Press [ ] or [ ] to select the frequency of
the required station.
Memory presetting
30 FM and 15 AM stations can be preset.
Automatic presetting
1
Press [OK] to select "LOWEST" or "CURRENT"
frequency.
2
Press [PLAY MENU] to select "A.PRESET" and
then press [OK].
"START?" is shown.
3
Press [OK] to start presetting.
To cancel, press [ ].
Manual presetting
1
Press [ ] or [ ] to tune in to the station.
2
Press [PROGRAM].
3
Press the alphanumeric buttons to select a
preset number.
Do steps 1 through 3 again to preset more stations.
The new station replaces any station that occupies
the same preset number.
Panasonic Corporation
Web Site: http://panasonic.net
© Panasonic Corporation 2012

Clock and timers

Setting the clock
This is a 24-hour clock.
1
Press [CLOCK/TIMER] to select "CLOCK".
2
Within 10 seconds, press [ ,
3
Press [OK].
Press [CLOCK/TIMER] to show the clock for a few
seconds.
Note:
Reset the clock regularly to maintain accuracy.
Sleep timer
The sleep timer switches off the system after the set
time.
Press [SLEEP] to select the setting (in minutes).
To cancel, select "OFF".
3 0 M N I 60 MIN 90 MIN
To show the remaining time
Press [SLEEP].
Note:
The play and sleep timer or the record and sleep
timer can be used together.
The sleep timer always comes first. Be sure not to set
an overlap of timers.

Sound and illumination effects

Sound effects
1
Press [SOUND] to select the sound effect.
2
Press [ , ] to select the desired setting.
] to set the time.
DJ effects
By main unit only
You can use the DJ effect function to adjust the sound
quality.
1
Press [DJ].
[1] to [6] light up in blue.
2
Press [1] to [6] to select the desired DJ effect.
The selected button lights up in red.
To cancel, press the button again.
3
Turn [CONTROL] to select the desired setting.
120 MIN O F F
Illumination effects
By main unit only
You can change the illumination pattern or color on this
system.
1
Press [ILLUMINATION] to select "PATTERN" or
"COLOR".
2
Within 5 seconds, turn [CONTROL] to select the
desired setting.
Sp En
RQT9800-M
L1212CH0