Installation - Electrolux ERN1701FOW Manual De Instrucciones

12 www.electrolux.com
Problem
The temperature in the ap‐
pliance is too low/too high.
If the advice does not lead to
the desired result, contact
the nearest Authorised
Service Centre.
8.2 Replacing the lamp
Disconnect the plug from the mains
socket.
1. Remove the screw from the lamp
cover.
2. Remove the lamp cover (refer to the
illustration).

9. INSTALLATION

9.1 Positioning
This appliance can be installed in a dry,
well ventilated indoor where the ambient
temperature corresponds to the climate
class indicated on the rating plate of the
appliance:
Possible cause
The temperature regula‐
tor is not set correctly.
The door is not closed
correctly.
The food products' tem‐
perature is too high.
Many food products are
stored at the same time.
The thickness of the frost
is greater than 4-5 mm.
The door has been
opened often.
3. Replace the used lamp with a new
4. Install the lamp cover.
5. Tighten the screw to the lamp cover.
6. Connect the plug to the mains
7. Open the door.
Make sure that the light comes on.
8.3 Closing the door
1. Clean the door gaskets.
2. If necessary, adjust the door. Refer
3. If necessary, replace the defective
Climate
class
SN
N
Solution
Set a higher/lower tempera‐
ture.
Refer to "Closing the door".
Let the food products tem‐
perature decrease to room
temperature before storage.
Store less food products at
the same time.
Defrost the appliance.
Open the door only if neces‐
sary.
lamp of the same power and
specifically designed for household
appliances (the maximum power is
shown on the lamp cover).
socket.
to "Installation".
door gaskets. Contact the Authorised
Service Centre.
Ambient temperature
+10°C to + 32°C
+16°C to + 32°C