Contents; Safety Instructions - ALFRA ROTABEST 80SP RL-E Manual De Instrucciones

eN
dear customer,
Thank you for purchasing an ALFRA product. Read these operation instructions closely before using
your device for the first time and keep them for later reference.

SAFETy inSTRucTiOnS

During work with this machine, improper handling and/or poor maintenance may result in significant
danger which could lead to the machine's destruction and serious accidents with considerable injuries.
Observe all safety instructions in this operation manual and contact the manufacturer if you have any questions.
!
Always...
• completely activate the switchable
permanent magnet
• activate the magnet on metallic,
ferromagnetic materials
• use the whole magnetic surface for working
• work on plane surfaces
• clean the magnetic surface and keep it clear of
dirt, swarf, metal shavings and welding sputter
• set the core drilling machine down gently to
prevent damage to the magnetic surface
• secure the machine with a safety belt when
drilling on walls or ceilings
• check connection cables for damage
• make sure the mains voltage matches the
machine's capacity
• follow the instructions in the operation manual
• familiarize new users with the safe use
of the machine
• wear safety goggles and ear protection
during work
• use a protective shield, if supplied
• observe local and country-specific guidelines
• use and store in a dry place
People with cardiac pacemakers or other medical appliances may only use
this machine following approval by their physician.
never touch rotating parts! keep hands and fingers away from the work area
while the motor is running! Failure to do so can result in severe injuries!
!
never...
• begin drilling without activating the magnet first
• work on round or curved objects
• drill several work pieces on top of one another
• modify the core drilling machine or
remove signs
• use the core drilling machine when damaged
or when parts are missing
• strain or damage the underside of the magnet
through heavy impact or blows
• use the core drilling machine without having
been properly instructed
• operate the machine without having read and
understood the complete operation manual
• use the core drilling machine to support,
lift or transport persons or loads
• carry out electric welding work on the work
piece at the same time as using the core
drilling machine
• store or operate the core drilling machine at
temperatures above 50°C (122°F)
• leave the machine hanging unsupervised
• allow the machine to come into contact with
corrosive materials
13