How To Tension The Chain; Pipe Clamp (Accessory) - Husqvarna K970 III Chain Manual De Instrucciones

How to tension the chain

WARNING! A slack diamond chain may
!
jump off and cause serious or even fatal
injury.
• If the play between drive link and bar is bigger than 1/
2" (12 mm) (A), the chain is too loose and must be
tightened.
• Loosen the bar nuts that hold the cover. Use the
combination tool. Then tighten the bar nuts by hand as
tight as you can.
• Stretch the diamond chain by tightening the chain
tensioning screw using the combination tool. Tighten
the diamond chain until it does not sag from the
underside of the bar.
• Use the combination tool to tighten the bar nuts while
lifting the tip of the bar at the same time. Check that
ASSEMBLING AND ADJUSTMENTS
A
you can pull the diamond chain round freely by hand
and that it does not sag from the underside of the bar.

Pipe clamp (Accessory)

For use with Husqvarna K 970 Ring and Chain and K
6500 Ring and Chain. A convenient accessory for
producing straight, precise cuts in concrete pipes.
–
English 11