Installing Universal Adapter Bracket - PEERLESS SmartMount RTFPA45 Manual Del Usuario

Remove two M5 x 20 mm screws from the rollbrake. Lift
2
adapter plate out from tilt bracket as shown.
NOTE: M5 X 25 mm screw may need to be loosened a
few turns to allow adapter bracket to be removed using
4 mm allen wrench (N).
Installing Universal Adapter Bracket to Screen
NOTE: If your screen has a VESA hole pattern skip to page 12.
3
Using the hole pattern shown in detail 1, attach the adapter plate to universal adapter
bracket (B) or dedicated adapter plate with four M10 x 15 mm screws (G) as shown.
Tighten screws using 6 mm allen wrench (K).
B
3-1
Remove bracket covers from screen brackets (C) as shown in fig. 3.1. Fasten two screen brackets (C) to the
gliders on universal adapter bracket (B)
BRACKET
COVER
ADAPTER PLATE
G
using four M5 x 10 mm flat head phillips screws (H) as shown in fig. 3.1.1.
C
fig. 3.1
ADAPTER
PLATE
BRACKET
DEDICATED
ADAPTER PLATE
GLIDERS
H
8 of 42
M5 X 20 MM
ROLL BRAKE
A
TILT
M5 X 25 MM
SCREW
ADAPTER PLATE HOLE PATTERN
FOR USE WITH
UNIVERSAL
ADAPTER
BRACKET OR
DEDICATED
ADAPTER PLATE
G
DETAIL 1
C
ISSUED: 03-08-07 SHEET #: 095-9271-2 10-26-09
SCREW
LARGE
HOLES
B
fig. 3.1.1