Installing And Removal Of Flat Panel Screen; Adjustment Of Flat Panel Screen - PEERLESS SmartMount RTFPA45 Manual Del Usuario

• Do not lift more weight than you can handle. Use additional man power or mechanical lifting equipment to safely
handle placement of the screen.
• Failure to lock brake pad with two M5 x 20 mm screws and lock tilt bracket with M5 x 25 mm screw can cause
screen to come off mount if hit accidentally.
Installing and Removing Flat Panel Screen
5 To attach screen to arm (A), insert the puck of adapter plate
into the tilt bracket slot as shown in figure 5.1. Attach brake
pad assembly as shown in Detail 5 so that the brake pad is
snug against the adapter plate. Adjust roll position of
adapter plate to level screen then lock puck in place by
tightening M5 x 25 mm screw on the underside of tilt
bracket using 4 mm allen wrench (N).
(M5 x 20 mm, M5 x 25 mm) screws.
screen from arm (A), remove two M5 x 20 mm screws and
brake pad. Lift screen out of tilt bracket.
CAUTION
• Do not tighten screws with excessive force. Overtightening
can cause damage to mount. Tighten M5 x 20 mm screws to
20 in. • lb (2.26 N.M.) maximum torque.

Adjustment of Flat Panel Screen

FOR PORTRAIT OR LANDSCAPE SCREEN ORIENTATION:
6
Remove two M5 x 20 mm screws and brake pad. Lift screen
out of tilt bracket. Rotate screen into portrait or landscape
position. Insert adapter plate puck into the tilt bracket slot as
shown in fig. 5.1. Attach brake pad to tilt bracket using two
M5 x 20 mm screws as shown in Detail 5. Tighten all
(M5 x 20 mm, M5 x 25 mm) screws.
TILT Adjustment: Adjust tension knob on side of mount to
desired tension to enable tilt adjustment and balance your
screen size and weight. Push or pull from top or bottom of
screen to adjust tilt as shown. The tilt can be adjusted to a
maximum of 10° forward or 5° backward. Retighten tension
knob.
ROLL Adjustment:
counter-clockwise, level screen then tighten M5 x 25 mm
screw using 4 mm allen wrench (N)
• Do not tighten screws with excessive force.
• Be careful not to pinch fingers when opening and closing
mount from the wall.
Tighten all
NOTE: To remove
Rotate screen either 5° clockwise or
as shown in bottom view.
CAUTION
WARNING
DETAIL 5
13 of 42
M5 X 20 MM SCREW (QTY. 2)
BRAKE PAD
ADAPTER PLATE
PUCK
TILT
BRACKET
A
M5 X 25 MM SCREW
TENSION
KNOB
BOTTOM
VIEW
ISSUED: 03-08-07 SHEET #: 095-9271-2 10-26-09
fig. 5.1
M5 X 25 MM
SCREW