Publicidad
Step 9
Carefully turn your unit over onto its front edges. Unfold
å
the BACK (G) and lay it over your unit.
Make equal margins along all four edges of the BACK (G).
å
Push on opposite corners of your unit if needed to make
it "square".
Fasten the BACK (G) to your unit using the NAILS (1N).
å
NOTE: Be sure to tap NAILS into the holes that line up
å
over the SHELF (D).
NOTE: Perforations have been provided for access
å
through the BACK. Carefully cut out the holes needed.
Page 14
These holes must line
up over the SHELF (D).
G
Caution
Do not stand the unit upright without the
BACK fastened. The unit may collapse.
(41 used in this step)
401632
1N
NAIL
Cut-outs (used for lifting)
www.sauder.com/services
Publicidad
