Publicidad
Step 11
Carefully stand your unit upright.
å
Before fastening the DOOR to your unit, be sure the
å
mounting screw is against the stops as shown in the
diagram. If it isn't, loosen the mounting screw to slide it
against the stops. Then tighten the mounting screw.
Fasten the RIGHT DOOR (I) to the RIGHT END (A) as
å
shown in the lower diagram. Use the screws in the
HINGES. You should start each SCREW a few turns before
completely tightening any of them.
Fasten a KNOB (93K) to the RIGHT DOOR (I). Use one
å
BLACK 1-1/4" FLAT HEAD SCREW (7S).
Repeat this step for the LEFT DOOR (J).
å
See the next step for DOOR adjustments.
å
BLACK 1-1/4" FLAT HEAD SCREW
(2 used for the KNOBS)
Page 16
7S
Stop
Mounting
screw
A
401632
Pro Tip: Lift with your
legs. And, you know,
your arms.
Hinge
93K
I
www.sauder.com/services
Publicidad
