Publicidad
Step 2
Slip the LARGE RUBBER SLEEVES (58G) over two TIE PLATES (3G). The
å
LARGE RUBBER SLEEVES will be a tight fi t.
Fasten the TIE PLATES (3G) to one of the SHELF MOLDINGS (M38). Use two
å
BLACK 9/16" LARGE HEAD SCREWS (1S).
Turn three CAM SCREWS (14F) into the other SHELF MOLDING (M38).
å
Push four HIDDEN CAMS (1F) into the SHELF (D) and DRAWER BRACE (M64).
å
Then, insert the metal end of a CAM DOWEL (2F) into the HIDDEN CAM in the
å
DRAWER BRACE (M64).
This hole
is closer to
this edge.
M38
Do not tighten the
HIDDEN CAMS in
this step.
M64
www.sauder.com/services
58G
3G
Arrow
1F
D
BLACK 9/16" LARGE HEAD SCREW
(2 used for the TIE PLATES)
This hole
is closer to
this edge.
2F
Arrow
Hole
401632
1S
M38
1F
The arrow in the HIDDEN
CAM must point toward the
hole in the edge of the board.
14F
Arrow
Hole
Page 7
Publicidad
