Inserting The Batteries; Setting The Clock - Sony HCD-T1 Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Inserting the
batteries
Insert two R6 (size AA) batteries into the
supplied remote.
Battery life
You can expect the remote to operate for about
six months using Sony SUM-3 (NS) batteries
before the batteries run down. When the
GB
batteries no longer operate the remote, replace
6
both batteries with new ones.
To avoid battery leakage
If you are not going to use the remote for a
long time, remove the batteries to avoid
damage caused by corrosion from battery
leakage.
Chapter 1: Setting up

Setting the Clock

You need to set the clock before using the
timer function. The clock shows the time in
the 24-hour cycle.
1
1
Press TIMER SET.
2
Press TIMER+ or – to display "CLOCK"
and press ENTER.
The hour indication begins flashing.
0
0
0
3
Set the current hour by pressing
TIMER+ or – and press ENTER.
The minute indication begins flashing.
8
1
0
4
Set the current minute by pressing
TIMER+ or – and press ENTER.
The clock starts operating.
To correct the clock setting
Repeat steps 1 to 4.
About the time indication
• The built-in clock shows the time in the
display when you press POWER to turn off
the power.
• The upper dot of the ":" in the time display
flashes for the 0 to 29 seconds of the minute
and the lower dot flashes for the 30 to 59
seconds.
2,3,4
ENTER

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Tc-tx1Sa-n1Sa-n11

Tabla de contenido