Ki Mobility Rogue XP Manual De Instrucciones Y Garantía página 29

V. SET UP & USE OF YOUR WHEELCHAIR
K. Replacing the Camber Tube
2. Instructions for removal with STANDARD 5th wheel (Fig. 16):
a. Remove 5th wheel from receiver and set aside.
b. Using a 3mm hex wrench and 8mm wrench, remove 5mm button head screw from receiver
(Fig. 16:A).
c. Using a 4mm hex wrench, loosen the two 5mm socket head screws (Fig. 16:B) until receiver
slides freely on camber tube.
3. Instructions for removal with DYNAMIC 5th wheel (Fig. 17):
a. Remove 5th wheel from receiver and set aside.
b. Using a 4mm hex wrench and 10mm wrench, remove the two 6mm socket head screws,
washers and locknuts from receiver (Fig. 17:A).
A
27
Fig. 16
A
Fig. 17
B