Optional Angle Adjustable Footplate - Ki Mobility Rogue XP Manual De Instrucciones Y Garantía

V. SET UP & USE OF YOUR WHEELCHAIR
Q. Optional Angle Adjustable Footplate
1. To adjust the angle of the optional angle adjustable footplates:
a. Loosen, but do not remove, the two M6 screws securing the footplate to the footplate
clamp with a 4mm Allen wrench.
b. Once loose, the footplate will easily rotate around the footrest extension tube.
c. Select the desired position and retighten the two M6 screws to 80 in./lbs.
2. Changing Position of the Optional Aluminum Flip-Up Footplate:
a. Remove both M6 screws from the footplate. There are M6 nylock nuts recessed on the
underside of the clamp. Be sure to prevent these from falling as you loosen the screws.
b. Relocate the footplate once the screws are loose by rotating either forward or rearward
depending on the desired angle. Once position is achieved, reinsert the screws in the
appropriate holes.
c. Fit the nuts into the slot underneath the clamp and tighten the screws securely.
Fig. 27
35