V. SET UP & USE OF YOUR WHEELCHAIR
E. Pediatric T-Arm Adjustment
1. Installation
a. Slide armrest post into receiver on side frame.
Ensuring the pin in lever engages the receiver
(Fig. 5).
2. Removing Armrest
a. Push lever (Fig. 6:A) in towards side guard panel
to release pin from receiver.
b. Pull armrest straight out of receiver.
3. Adjusting Arm Height in Receiver
a. Remove armrest from chair.
b. Remove two 6mm screws from side guards
(Fig. 7:A).
c. Remove M4 screw (Fig. 7:B) from side guard
post stop through side guard post but do not
pull entirely out. Screw can stay in the lever
assembly. Repeat on other arm.
d. Reset the post stop and lever assembly on side
guard post to desired position. Retighten M4 screw (Fig. 7:B). Repeat on other arm.
e. Place side guard in desired position and replace two 6mm screws (Fig. 7:A) to secure side
guard in place. Tighten two 6mm screws. Repeat on opposite arm.
f. Replace armrest assemblies into receiver (Fig. 5).
Fig. 6
A
Fig. 5
A
20
Fig. 7
B