Front Seat Height Adjustment; Rogue Alx - Rear Seat Height Adjustment - Ki Mobility Rogue ALX Manual De Instrucciones Y Garantía

V. SET UP & USE OF YOUR WHEELCHAIR
K. Front Seat Height Adjustment
The front seat height can be adjusted in ½" increments by repositioning the caster wheel within
the fork.
1. Use two 4mm Allen wrenches to remove the cap screws
and push the internally threaded axle from one hole
location and move up or down to the desired location.
2. Reposition the two 6mm screws and tighten to 80 in/lbs.
3. Resquare caster wheels as noted in Section N.
L. Rogue ALX - Rear Seat Height Adjustment
Rear seat height can be adjusted by repositioning the Tubular
Component System (TCS).
1. Remove your wheels by depressing the buttons on the
quick release axle.
2. Use a 3mm Allen wrench and 8mm open end wrench to
remove the 2 bolts (Fig. 15:A) holding the upper and lower
mounting brackets together. Reposition the mounting
brackets to the desired height and replace the 2 M5 bolts.
3. Repeat on both sides of the wheelchair.
NOTE: Height adjustments are in ¼" increments.
NOTE: A front caster adjustment should be made to correspond with any change in seat angle.
WARNING: Lowering the seat height at the rear of the seat 0.5" or 2 positions of 0.25"
increments will decrease the rearward stability by ½ degree. The more you move your rear wheels
forward, the more likely your chair will tip over backwards.
Always make adjustments in small increments and check the stability of your chair with a spotter
to prevent a tip-over. We recommend you use anti-tip tubes until you adapt to the change and are
sure you are not at risk to tip over.
DANGER: Failure to heed these warnings may cause serious injury or death.
Fig. 14
26
Fig. 15
A