Hold Button; Last Number Redial Button; Flash Button; Troubleshooting - Clarity Power P400 Manual Del Usuario

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Figure 12
H. Hold Button
To put the line on hold, simply press
the HOLD button and return the
handset to its cradle. Notice the red
light HOLD indicator. When you
pick up an extension phone on the
same line, the P400 will disconnect.
Putting the call on hold also mutes
the handset.
I. Last Number Redial Button
The P400 phone remembers the last
number dialed from the phone up to
32 digits. Lift the handset and simply
press the REDIAL button to dial the
last number dialed.
If any problem should arise during use of your P400 phone, try the suggestions
listed below. Should the difficulty persist, contact Clarity or your authorized
dealer for assistance.
SYMPTOM
No dial tone
No number dialed when
memory button pressed
Call cannot be dialed, or
is dialed slowly
No audible ring
14
All manuals and user guides at all-guides.com
Telephone Operations
FLASH
CLARITY
BOOST
POWER

Troubleshooting

CAUSE AND CORRECTIVE ACTION
Check all phone cord connections.
No number stored in that memory button.
See "Programming The Photo Directory", p. 12.
See "Installation" section to
reset the dial mode switch, p. 11.
Make sure the ringer is not set
to "Off" position.
BOOST
Figure 13
J. Flash Button
The flash feature is used to access
special telephone functions and ser-
vices available from your local phone
company, such as: call waiting, 3-way
calling and others. Press this button
to activate the flash feature.
BOOST
Figure 14
FLASH
FLASH
CLARITY
POWER

Publicidad

Tabla de contenido

Solución de problemas

loading

Tabla de contenido