Assembling The Stand - Pioneer PDK-TS12 Manual De Instrucciones

Assembling the Stand

Note
Always assemble it on a flat table etc.
Insert the screws in the holes vertically and do not tighten
them with more force than necessary.
Assembly Procedure
1
Select the support columns to attach (see
"Support Columns Used / Not Used
Table" on Page 13).
Select the support columns according to the speakers
that you have purchased with reference to the following
stipulation (Only one type of the two types of available
support columns should be used).
When the speakers you have purchased are
PDP-S38 or PDP-S37.
[Support column used: support column S (short
columns)]
Support column used:
support column S
(short columns)
When the speakers you have purchased are
PDP-S39.
[Support column used: support column L (long
columns)]
Support column S (short columns) cannot be used.
Support column used:
support column L
(long columns)
14
En
2
Secure the support column to the stand
with the Installation screws 1 (4 locations
on the left and right).
Using the enclosed hexagonal wrench, first loosely
attach the top attachment screw, then loosely attach
the bottom attachment screw.
Illustration: when using support columns S
The larger holes
are on the front.
Installation screws
(M8 x 16 mm: silver)
3
Fully tighten the Installation screws
(4 locations on the left and right).
Fully tighten the attachment screws.
Note
Be sure to carefully store the unused support columns, the
hexagonal wrench, the C wrench, and the Operating
Instructions together.
1