SATA J Serie Manual Del Uso página 16

Operation guideline:
Caution:
Please read the instruction carefully before operating the machine.
Before the use:
1 ） Charging：
This charger and machine shall be used together. Do not use other chargers.
The machine has a protection circuit. When the battery is low, the protection circuit is turned on and the machine stops rotating.
The machine may become hot under the high temperatures or after a long period of operation. At this time, do not charge
immediately but wait until the battery is cooled. Otherwise, the service life of battery will be shortened or the charging failure may
be caused due to overheating.
For the first charging or after a long period of storage, the efficiency of first charging may only reach about 60%. After 2-3 charging
and discharging cycles, the battery efficiency may reach 100%.
2） Installation and removal of battery pack （see Figure A）:
Press the lock buttons on both sides of battery pack and pull it out. To insert the battery pack, simply push it into the machine. Avoid
the excessive force.
3） Selection of working mode （see Figure E and Figure H）:
This machine has three working modes optional （3）. Drill, hammer drill or screw tightening may be selected according to the
working demands:
a）Drill function:
Rotate the working mode selection ring （3） to align the drill mark
function;
b）Hammer drill function:
Rotate the working mode selection ring （3） to align the hammer mark
appropriate pressure to the machine during operation so as to activate the hammer drill function;
c）Screw tightening function :
Rotate the working mode selection ring （3） to align the screw mark
the torque ring（4） to select the appropriate torque position against the arrow to start the screw tightening.
4） Auxiliary handle installation （see Figure B）:
Rotate the auxiliary handle counterclockwise, align two grooves on the auxiliary handle with two bosses on the machine as shown in
Figure B, make sure that they are fully engaged and then rotate the auxiliary handle clockwise until it is tightened.
Operation:
1 ） Start/stop （see Figure C）:
Press and hold the switch （1） to start the machine, and release it to stop the machine. The switch has the brake function. When
the switch is released, the chuck stops rotating immediately.
Change the force applied to the switch to regulate the rotating speed. The range of adjustment is between 0 and the maximum
rotating speed. The smaller the force is, the lower the rotating speed is. The drilling starts slowly and stably. Prevent the shutdown of
machine due to the excessive load.
Warning:
Do not operate at low speed for a long time. Otherwise the machine will be. overheating inside.
2） Switch lock （see Figure C）:
16
51012
中文
EN DE RU
with the arrow on the enclosure to activate the drill
with the arrow on the enclosure, and apply the
with the arrow on the enclosure, and then adjust
KO PT JA ES