SATA J Serie Manual Del Uso página 17

Taladro eléctrico de impacto / desatornillador sin escobilla de batería de litio de 18v
Ocultar thumbs Ver también para J Serie:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 73
The switch has the lock protection function which helps to avoid the accidental activation of the hand drill. Lock the machine by
adjusting the reversing yoke (2) to the center position.
3) Rotation reversing (see Figure C):
Forward: Push the side of Reversing yoke marked with "
Reverse: Push the side of reversing yoke marked with "
screw.
Warning:
The rotating speed can only be changed after the machine is completely still.the machine is completely still.
4) Speed change (see Figure C):
Move the shift lever (3) downwards to the position "1":
high torque / low rotating speed for drilling a thicker bit or driving the screw.
Move the shift lever (3) upwards to the position "2":
low torque / high rotating speed for drilling a thinner bit.
When the mechanical shift lever cannot be toggled due to teeth collision, tap the switch to rotate the motor and then change the
position.
Warning:
The rotating speed can only be changed after the machine is completely still.
5) Installation or removal of bit (see Figure G):
Caution:
When installing or removing the bit, be sure to confirm that the drill has been turned off and that the battery pack has been
removed.
Hold the machine in one hand, hold the chuck collar in the other hand, turn the chuck counterclockwise to open it, load the bit
into the chuck, push it as far as possible, and then tighten the chuck by rotating the collar clockwise. Hold the collar and rotate it
counterclockwise to remove the bit.
6) Torque and drill setting (see Figure F):
Rotate the torque adjusting ring to adjust the torque of machine. When the number 1 on the torque adjusting ring is aligned with
the indicating arrow on the machine, the torque is minimal. When the mark "21" on the torque adjusting ring is aligned with the
indicating arrow above the machine, the torque is maximum. Select the drilling mode to conduct the drilling.
Setting reference is as follows:
1-3
4-8
9-13
14-18
19-21
51012
Drive the screw into the soft or hard material
中文
"to the end (left side) for drilling a hole and screwing the screw.
" to the end (right side) for releasing or unscrewing the screw the
Rotate the small screw
Drive the screw into the soft material
Drive the screw into the hard material
Drive the larger screw
EN
DE
RU
KO
PT
JA
ES
17

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

51012

Tabla de contenido