JVC GR-AXM33UM Manual De Instrucciones página 43

Transmitted beam
effective area
15°
15°
When using the remote control, be sure to
point it at the remote sensor. The above
illustration shows the approximate transmitted
beam effective area for indoor use.
The transmitted beam may not be effective or
may cause incorrect operation outdoors or
when the remote sensor is directly exposed to
sunlight or powerful lighting.
Interval Timer Indicator
1MIN INDEX
1 2S
Rec Time Indicator
START/STOP
VISS
INT. TIME
REC TIME
RM-V700U
(optional)
Remote sensor
LCD monitor
or viewfinder
Index Code
Marking
RM-V705U
OR
(provided)
FEATURE: Self-Timer, Animation and Time-Lapse
PURPOSE: The remote control lets you set/release
Interval Timer and Rec Time functions
as well as the Menu Screen.
OPERATION: Self-Timer
1) Set
Instead of performing steps 1 through
4 on pg. 34 ("Self-Timer"), press INT.
TIME on the remote control. Each
time INT. TIME is pressed, the
Interval Timer indicator appears,
changing in the following order: 15S,
30S, 1MIN, 5MIN and No indication
(off).
2) Release
Instead of setting "INT. TIME" to
"OFF" in the Menu, press INT. TIME
on the remote control until the
Interval Timer indicator disappears.
Animation
1) Set
Instead of performing steps 1 and 2
on pg. 35 ("Animation"), press REC
TIME on the remote control. Each
time REC TIME is pressed, the Rec
Time indicator appears, changing in
the following order: 1/4S, 1/2S, 1S,
5S and No indication (off).
2) Release
Instead of using the Menu in step 5
on pg. 35, press REC TIME on the
remote control until the Rec Time
indicator disappears.
Time-Lapse
1) Set
Instead of performing steps 1 through
3 on pg. 35 ("Time-Lapse"), press
INT. TIME and REC TIME on the
remote control. Each time INT. TIME
is pressed, the Interval Timer
indicator appears, changing in the
following order: 15S, 30S, 1MIN,
5MIN and No indication (off). Each
time REC TIME is pressed, the Rec
Time indicator appears, changing in
the following order: 1/4S, 1/2S, 1S,
5S and No indication (off).
2) Release
Instead of using the Menu in step 5
on pg. 35, press INT. TIME and REC
TIME on the remote control until the
indicators disappear.
NOTE: Also refer to pgs. 34 and 35.
FEATURE: Index Code Marking (RM-V700U only)
PURPOSE: To give you automatic access to any
selected point on a recording.
OPERATION: 1) Press VISS once to place the index
code. "INDEX" blinks during
marking.
NOTE: If VISS is pressed during Record-
Standby mode, the mark is placed
where START/STOP is pressed.
43
EN