Worx WT520 Manual Del Usuario página 17

WARNING: To be accurate, an estimation of
exposure level in the actual conditions of use
should also take account of all parts of the operating
cycle such as the times when the tool is switched off
and when it is running idle but not actually doing
the job. This may significantly reduce the exposure
level over the total working period.
Helping to minimise your vibration exposure risk.
ALWAYS use sharp chisels, drills and blades
Maintain this tool in accordance with these
instructions and keep well lubricated (where
appropriate)
If the tool is to be used regularly then invest in anti
vibration accessories.
Plan your work schedule to spread any high
vibration tool use across a number of days.
OPERATING INSTRUCTIONS
NOTE: Before using the tool, read the
instruction book carefully.
WARNING: Do not release the handle until
the saw blade come to complete stop and do
not touch saw blade while the saw blade is
running.
Intended use: The tool is intended for ripping
and cross-cutting wood and other materials in
straight cutting lines, while resting firmly on
the work piece.
ASSEMBLY AND OPERATION
ACTION
BEFORE OPERATION
Removing the battery pack
Charging the battery
Installing the battery pack
ASSEMBLY
Mounting and Removing the
Blade
NOTE: Lock or loose the blade
bolt, the spindle lock button
should be pressed.
WARNING: Always
remove the battery
before changing the blade!
20V Cordless Brushless Circular saw
WORKING HINTS FOR YOUR
TOOL
If your power tool becomes too hot, please run your
circular saw no load for 2-3 minutes to cool the
motor. Avoid prolonged usage at very low speeds.
FIGURE
Protect saw blades against impact and shock.
Cutting with extreme force can significantly
reduces the performance capability of the tool and
reduces the service life of the saw blade. Sawing
See Fig. A1
performance and cutting quality depend essentially
See Fig. A2
on the condition and the tooth count of the saw
blade. Therefore, use only sharp saw blades that are
See Fig. A3
suited for the material being cut.
Choice of blades: 24 teeth for general work, approx.
40 teeth for finer cuts, more than 40 teeth for very
fine cuts into delicate surfaces, diamond for tile,
cement board, etc.
Only use saw blades recommended.
See Fig. B
MAINTAIN TOOLS WITH
CARE
Remove the battery before carrying out any
adjustment, servicing or maintenance.
Keep tools sharp and clean for better and safer
performance. Follow instructions for lubricating and
changing accessories. Inspect tool cords periodically
and if damaged, have repaired by authorized service
facility. Your power tool requires no additional
lubrication or maintenance. There are no user
Safety switch and On/Off
trigger
WARNING: To avoid
cutting injury from the
sharp blade, please don't put
your hands around the Base
Plate.
NOTE: Keep the dust adapter
connected to dust collecting
device when using the tool.
Rip and Cross Cutting
NOTE: The cutting line of
saw blade is aligned with the
cutting mark 0°.
Parallel Guide
Adjusting the Cutting Depth
Adjusting the Cutting Angle
NOTE: The cutting line of
saw blade is aligned with the
cutting mark 45°.
Pocket /Plunge
Sawdust Removal
See Fig. C
See Fig. D1, D2
See Fig. E1, E2
See Fig. F1, F2
See Fig. G
See Fig. H1, H2
See Fig. I
17
EN