Genesis GLMT12 Manual Del Operario página 7

• always wear safety glasses or goggles.
are not safety glasses.
• Hold the Oscillating Tool by its insulated gripping surfaces to avoid
electrical shock from unseen "live" wires.
• always hold the tool firmly. DO not
• Check your work area for proper clearances before cutting.
avoid cutting into your workbench, the floor, etc.
• DO not cut nails or screws
purpose. Inspect your material before cutting
• Before switching on the tool,
• Do not use tool if switch does not turn it on or off.
controlled by the switch is dangerous and must be repaired.
• Wear cushioned protective gloves to minimize the vibration.
vibration may cause personal injury.
• Do not wet-sand with this tool.
cause electric shock and serious personal injury.
• always disconnect battery pack from tool
position before any assembly, adjustments or changing of accessories. Following this instruction
will reduce the risk of serious personal injury.
• Do not place battery tools or their batteries near fire or heat.
reduce the risk of explosion and possibly personal injury.
• never use a battery which has been dropped or received a sharp
blow.
A damaged battery is subject to explosion. Properly dispose of a dropped or damaged
battery immediately.
• Use designated battery pack (genesis™ -Model gLaB12) and
charger (genesis™- Model gaCH12) for this tool.
may result in a risk of fire.
iMPOrTanT SaFETY inSTrUCTiOnS FOr CHargEr &
BaTTErY
• Save These instructions.
instructions for your battery charger.
• Before Using the battery Charger,
on (1) Battery Charger, (2) Battery , and (3) Product using battery.
• Use only the charger
in this manual. Do not substitute any other charger.
• Do not recharge battery in damp or wet environments.
battery pack to water or rain.
• Do not operate charger with damaged cord or plug.
• Do not operate charger if it has received a sharp blow,
otherwise damaged in any way. Take it to a qualified serviceman.
unless you are using a blade specifically designed for this
.
be sure the blade is not contacting the work piece.
Water or moisture entering the motor housing can
SAVE THESE INSTRUCTIONS
This manual contains important safety and operating
which accompanied your product or direct replacements as listed
Normal prescription eye or sunglasses
leave the tool running unless hand held.
or place the switch in the locked or off
use of any other batteries
read all instructions and cautionary markings
This will
Any tool which can not be
Excessive
This will
Do not expose
Replace immediately.
been dropped or
7