General Power Tool Safety Warnings; Work Area Safety; Electrical Safety - Parkside PSBM 750 B3 Traducción Del Manual De Instrucciones Original

Total vibration value
Total vibration values (vector total of three direc­
tions) determined in accordance with EN 62841:
Drilling in metal
(Main handle) a
h,D
(Additional handle)
K = 1 .5 m/s
2
Hammer drilling in concrete
(Main handle) a = 11 .674 m/s
h,ID
(Additional handle) a
h,ID
NOTE
► The vibration emission values and the noise
emission values given in these instructions
have been measured in accordance with a
standardised test procedure and can be used
for comparison of the power tool with
another tool .
► The specified total vibration values and the
noise emission values can also be used to
make a provisional load estimate .
WARNING!
► Depending on the manner in which the
power tool is being used, and in particular
the kind of workpiece that is being worked,
the vibration and noise emission values can
deviate from the values given in these instruc­
tions during actual use of the power tool .
► Try to keep the load as low as possible .
Measures to reduce the vibration load are,
e .g . wearing gloves and limiting the working
time . Wherein all states of operation must be
included (e .g . times when the power tool is
switched off and times where the power tool
is switched on but running without load) .
PSBM 750 B3
= 7 .245 m/s , K = 1 .5 m/s
2
a = 5 .947 m/s
h,D
, K = 1 .5 m/s
2
= 9 .645 m/s , K = 1 .5 m/s
2
General power tool
safety warnings
2
WARNING!
,
2
► Read all safety warnings, instructions,
illustrations and specifications provided
with this power tool. Failure to follow all
2
instructions listed below may result in electric
2
shock, fire and/or serious injury .
Save all warnings and instructions for future
reference.
The term „power tool" in the warnings refers to
your mains­operated (corded) power tool or
battery­operated (cordless) power tool .

1 . Work area safety

a) Keep work area clean and well lit. Cluttered
or dark areas invite accidents .
b) Do not operate power tools in explosive
atmospheres, such as in the presence of flam­
mable liquids, gases or dust. Power tools create
sparks which may ignite the dust or fumes .
c) Keep children and bystanders away while
operating a power tool. Distractions can cause
you to lose control .

2 . Electrical safety

a) Power tool plugs must match the outlet. Never
modify the plug in any way. Do not use any
adapter plugs with earthed (grounded)
power tools. Unmodified plugs and matching
outlets will reduce risk of electric shock .
b) Avoid body contact with earthed or
grounded surfaces, such as pipes, radiators,
ranges and refrigerators. There is an increased
risk of electric shock if your body is earthed or
grounded .
c) Do not expose power tools to rain or wet
conditions. Water entering a power tool will
increase the risk of electric shock .
GB │ MT │ 33 ■