Stihl FC 96 Manual De Instrucciones página 14

English
Plan the best route for edging.
N
Always hold and operate your edger
on the right-hand side of your body.
Adjusting Depth of Cut
2
1
A
To reduce the risk of injury, shut off
N
the engine.
Loosen the wingnut (1)
N
counterclockwise.
Push wheel (2) upwards to increase
N
the depth of cut (A) or downwards to
reduce the depth of cut (A).
12
Adjust correctly
3
B
The depth of cut depends on the
unevenness of the ground, your height
and the way you hold the edger. Use the
following procedure:
Adjust the depth wheel (2) so that
N
the blade (3) just touches the
ground or breaks the surface of the
soil by no more than 5 mm (0.2 in).
Tighten down the wingnut
N
clockwise.
Standing in the normal working
N
position, check the depth of cut
2
again and correct it if necessary.
WARNING
Do not adjust the deflector.
The deflector has been set at the factory
so that the arrow on the deflector and
the open side point away from the
FC 96, FC 111