Mounting The Loop Handle; Adjusting The Throttle Cable - Stihl FC 96 Manual De Instrucciones

English

Mounting the Loop Handle

Your new power tool comes with the
loop handle mounted on the drive tube,
but it must be turned and lined up to suit
your requirements.
Adjusting the Loop Handle
1
Use the combination wrench to
N
loosen the screw (1).
Turn the handle to the vertical
N
position.
14
A
The loop handle can be adjusted to suit
the height and reach of the operator and
the application by changing
distance (A).
Recommendation: distance (A):
about 6 in (15 cm)
Slide the handle to the required
N
position.
Tighten down the screw with the
N
combination wrench so that the
handle cannot be rotated on the
drive tube.

Adjusting the Throttle Cable

It may be necessary to correct the
adjustment of the throttle cable after
assembling the machine or after a
prolonged period of operation.
Adjust the throttle cable only when the
unit is completely and properly
assembled.
Set the throttle trigger to the full
N
throttle position.
Carefully rotate the screw in the
N
throttle trigger in the direction of the
arrow until you feel initial resistance.
Then rotate it another half turn in the
same direction.
FC 96, FC 111