Ryobi RTS23 Manual Del Operador página 17

INSTALLING THE CROSSPIECE
See Figure 10.
Locate the following parts:
Lock Nut (M5) ............................................................. 4
Bolt (M5 x 35 mm) ...................................................... 4
Crosspiece .................................................................. 1
 Place the crosspiece in position as shown, aligning the
holes in the crosspiece with the holes in the lower part
of the stand.
 Slide each of the four bolts through the holes in the
crosspiece and the holes in the legs.
 Place a lock nut over each bolt. Securely tighten the nut
using an 8 mm wrench and socket.
INSTALLING WHEELS ONTO THE STAND
See Figure 11.
Locate the following parts:
Wheel .......................................................................2
Washer (OD16 x ID8 x 2t) .........................................4
Lock Nut (M8) ...........................................................2
 Slide a washer, a wheel, and another washer onto each
axle.
 Thread a lock nut onto the axle and securely tighten,
using a 13 mm wrench.
BOLT
INNER
STAND
SUPPORT
BRACKET
ASSEMBLY
CROSSPIECE
LOCK
NUT
OUTER
STAND
SUPPORT
BRACKET
Fig. 10
INSTALLING THE HANDLE ASSEMBLY
See Figure 12.
Locate the following parts:
Handle Assembly ........................................................ 1
Handle End Cap.......................................................... 1
 Remove the hex nut from the bolt in the handle but do
not remove the bolt or washer.
 Place the hex nut into the recessed hole on the back of
the height/bevel adjusting handwheel and hold in place.
 Insert the handle, bolt, and washer into the hole on the
height/bevel adjusting handwheel.
 Using a flathead screwdriver, turn the bolt clockwise and
tighten in place.
 Cover the end of the handle with the cap.
WASHER
NUT
17 - English
AXLE
WASHER
WHEEL
HANDWHEEL
HANDLE
BOLT
WASHER
LOCK
NUT
Fig. 11
HANDLE
END CAP
Fig. 12