Ryobi RTS23 Manual Del Operador página 33

TO USE THE SLIDING TABLE EXTENSION
See Figures 43 - 44.
Increase the length of the saw table by using the table
extension.
 Set the rip fence to 14 in.
WARNING:
The rip fence must be locked in the 14 in. position to
ensure the accuracy of the secondary scale measurement
and to provide proper support of the workpiece when
using the table in the extended position. Failure to
position the rip fence correctly will cause inaccurate
workpiece measurements and could result in serious
personal injury.
 Pull the front table locking lever toward you to unlock the
lever. Repeat with the back lever.
 Slide the table extension to the desired width.
NOTE: Use the scale on the front rail when a specific
width is desired.
 Once the table extension are set to the desired width,
relock the front and back locking levers by pushing the
levers back towards the saw base.
OPERATION
33 - English
SLIDING TABLE
EXTENSION
TABLE
LOCKING LEVER
SECONDARY
SCALE INDICATOR
SLIDING TABLE
EXTENSION
Fig. 43
Fig. 44