Ryobi RTS23 Manual Del Operador página 25

TO MOVE THE SAW
See Figure 24.
 Close the leg stand as described earlier in the To open/
close (set-up/tear down) the leg stand section.
 Holding the leg stand firmly, pull the leg stand toward you
until the leg stand and saw are balanced on the wheels
like a handtruck.
 Push the saw to the desired location then either open the
leg stand for immediate saw operation or store the saw
in a dry environment.
STORING TABLE SAW ACCESSORIES
See Figure 25 - 28.
When not in use the rip fence, riving knife, wrenches, blade
guard, miter gauge, and push stick may be stored beneath
the saw table.
Additional storage for the push stick is located on top of the
rip fence. To use the storage area, insert the tip of the push
stick into the slot until it clicks into place.
BLADE
GUARD
STORAGE
BLADE
GUARD
ASSEMBLY
KNOB
KNIFE STORAGE
PUSH STICK
Fig. 24
Fig. 25
25 - English
RIP FENCE
MITER
STORAGE
GAUGE
BLADE WRENCH STORAGE
BLADE
WRENCHES
RIVING
PUSH STICK
MITER GAUGE
STORAGE
RIP
FENCE
Fig. 26
KNOB
Fig. 27
RIP FENCE
PUSH STICK
STORAGE
Fig. 28