Eu Declaration Of Conformity - stayer CS85 Manual De Instrucciones

It is necessary to determine safety measures to protect
users, based on an estimation of the exposition during
real use conditions. For this purpose, they must take
into account all phases of the operating cycle as the
time during which the electrical toll is disconnected
and the time during which it is connected but without
working.
The values of noise and vibration were detected in
compliance with regulations and provisions as stated
in the Declaration of Conformity.
The right to applying
modifications in the framework of improvements
without prior advice is reserved.
Therefore, no responsibility
dimensions, indications and observations indicated
in these instructions for use. The expectation of
legal claims based on these instructions for use is
excluded.
= Power
= Revolutions when idling
= Disk
= Weight
L = Acoustic power level
WA
L = Acoustic pressure level
PA
= Vibration
These data are valid for nominal voltages of [U] 230/240 V
~ 50/60 Hz – 110/120 V ~ 60 Hz. The values may change
if the voltage is lower and in specific embodiments for
certain countries.
The typical sound pressure level, determined by means
of an A-filter, amounts to: Sound pressure level 88 dB(A);
acoustic power level 99 dB(A). Tolerance K= 3dB.
Wear ear protectors!
Total level of vibrations (Vector sum of three directions)
determined according to EN 60745: a
m/s .
2
The vibration level indicated in these instructions has
been determined according to the measuring process
set in regulation EN 60745 and may serve as a basis for
comparing electric tools. It is also adequate for provisionally
estimating stress suffered due to vibrations. The vibration
level as indicated has been determined for the main
applications of the electric tool. To this end the vibration
level may be different if the electric tool is used for other
applications with different tools, or if maintenance thee of
were deficient. This may suppose a drastic increase of
stress due to vibrations during the total working time.
technical and optical
is taken for the
= 4 m/s , K = 1.5
h 2
ENGLISH
12
To accurately determine stress suffered due to vibrations,
it is necessary considering as well those times during
which the apparatus is disconnected or operating but
without really being utilized. This may suppose a drastic
reduction of stress due to vibrations during the whole of
the working time. Establish additional safety measures for
the user against vibrations, as for example: Maintenance
of the electric tools and of the implements, keeping your
hands warm, organizing working sequences.
6.2. EC Declaration of Conformity
The undersigned : STAYER IBERIA, S.A.
With address at:
Called Sierra de Caporal, 7
Área Empresarial Andalucía - Sector 1
28320 PINTO (MADRID)
Tel.: +91 691 86 30 / Fax: +34 91 691 86 31
CERTIFIES
That the machine:
Type: SEMIAUTOMATIC CHAIN SHARPENER
Model: CS85
We declare under our own responsibility that the product
as described under "Technical data" is in conformity with
the following standards or standardized documents:
UNE EN 61029-2-10:20111/A11:2013: UNE EN 55014-
1:2008/A2:2012,
UNE EN 61000-3-2:2014, UNE EN 61000-3-3:2013 in
accordance with regulations 2006/42/EC, 2004/108/CE,
2006/95CE.
Ramiro de la Fuente
Director General
12
UNE EN 55014-2:º998/A2:2009,
January 5, 2017