Attaching An Ipod/Iphone - Sony XDP-MU110 Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Attaching an iPod/iPhone

Compatible iPod/iPhone models
See "About iPod/iPhone" (page 18) or visit
the support page:
http://esupport.sony.com
http://www.sony.com/caraudio
Notes
• Start the car's engine before connecting the
iPod/iPhone. Depending on the device,
malfunction or damage may occur if it is
connected before starting the engine.
• Remove the case or cover from the iPod/iPhone
before setting it in the cradle to ensure a stable
installation.
• Sony cannot accept responsibility in the event
that data recorded to an iPod/iPhone is lost or
damaged when using an iPod/iPhone
connected to the cradle.
• For details on environmental conditions for
operating the iPod/iPhone, check the website of
Apple Inc.
1
Push the PUSH RELEASE button to
stretch the arm of the cradle (), and
then set the iPod/iPhone in the cradle
().
Notes
• When setting the iPod/iPhone, hold the
iPod/iPhone at the same angle as that of the
connector on the cradle.
• When setting the iPod/iPhone, hold the
cradle securely.
2
Press the arm down gently and set your
iPod/iPhone in the cradle.
Press the iPod/iPhone backward until it
touches to the cushion in the center of
the cradle (
), and hold the iPod/
iPhone securely while pressing the arm
down (
).
Notes
• Make sure that there is no gap between the
iPod/iPhone and the arm when setting the
iPod/iPhone in the cradle.
• Make sure that the arm holds the iPod/iPhone
securely. When the temperature is low, it may
be difficult to lock the iPod/iPhone in place.
Tips
• The system plays back music from the iPod/
iPhone when the iPod/iPhone is in the play
mode as you set it on the cradle.
• An iPod/iPhone is charged when set in the
cradle, and the system is turned on.
Gap
15

Publicidad

Capítulos

Tabla de contenido

Solución de problemas

loading

Tabla de contenido