The System Components; Dsp Master Unit - Sony XDP-MU110 Manual De Instrucciones

The System Components

This section contains explanations on the location of controls and their basic operations.

DSP master unit

 Sound setting switches page 8
Set each switch according to your car
type/interior.
 SOURCE indicator
You can check the status of the DSP
master unit.
Indicator Status
Turns blue. A car audio unit is selected as
the source.
Turns red. An iPod/iPhone is selected as
the source.
Flashes blue. Diagnostic error. See
"Troubleshooting" (page 20).
Flashes red. Overload error when an
iPod/iPhone is selected as the
source. See
"Troubleshooting" (page 20).
Flashes blue Temperature detection is
and red working. See
alternately. "Troubleshooting" (page 20).
 INPUT SELECT switch
Select either 2-channel or 4-channel
sound from the car audio unit. Select
"2ch" if you connect only the front car
speakers to the DSP master unit, with
High Level Input connection.
 RESET
Press to reset the DSP master unit
settings.
1 2 3
Note
• Avoid touching the top of the DSP master unit
during use, as it becomes hot over time.
4
5