Before Installation; Installation - Sony XDP-MU110 Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Mounting sheet
Strap
Cord clamp
Cradle cable
Cleaning sponge for suction cup

Before Installation

• Mount the cradle on the dashboard where it
is smooth and horizontal.
• Make sure that the surface of the dashboard
where you intend to install the cradle is
clean. Dirty surfaces will make the adhesive
strength of the suction cup weak, and may
cause unstable installation of the cradle.
• The suction cup may leave a mark on the
dashboard, depending on the surface
material. Your consideration is requested.
To attach the mounting sheet
Attach the mounting sheet to the dashboard
before installing the cradle.
Notes
• Choose the mounting location carefully.
Practice installation before you actually mount
the sheet, if necessary.
• Removing the mounting sheet from the
dashboard decreases the adhesive strength of
the mounting sheet. It should not be reused
after removal.
1
Peel the paper from the mounting sheet, and
then stick the mounting sheet to the
dashboard.
Allow 24 hours after sticking the mounting
sheet on the dashboard before installing the
cradle on it.

Installation

1
Mount the clip of the strap on the
defroster of your car.
2
Place the hoop of the strap over the
cradle and attach the strap as shown in
the illustrations below.
Peel off paper
11

Publicidad

Capítulos

Tabla de contenido

Solución de problemas

loading

Tabla de contenido