Rm-X251 Card Remote Commander - Sony XDP-MU110 Manual De Instrucciones

RM-X251 Card remote
commander
Remove the insulation film before use.
 SOURCE/OFF button
Press to turn off the power/change the
source between a car audio unit and an
iPod/iPhone.
Press and hold more than two seconds
to turn off the system. The indicators on
the DSP master unit and the cradle turn
off.
 FAD/BAL (FRONT/CNT/REAR)
buttons page 9
Press to adjust the balance between the
speakers.
 VOL +/– buttons*
1
 LEFT/RIGHT buttons page 9
Press to adjust the speaker balance.
Press and hold the CNT button () to
return to the default setting.
 BASS (–/CNT/+) buttons page 9
Press to adjust the bass level.
 ALO (Automatic Level Optimizer)
button* page 10
1
Adjust the playback volume level of an
iPod/iPhone to the optimum level:
"ON," "OFF."
 / buttons*
Press to skip tracks.
 TREBLE (–/CNT/+) buttons page 9
Press these buttons to adjust the treble
level.
 SUB VOL +/– button*
Press to adjust the subwoofer volume if
you connect a subwoofer to the system
and the SUBWOOFER switch on the
DSP master unit is set to "Y."
*1 These buttons work only when an iPod/
iPhone is selected as the source and the music
player on an iPod/iPhone is activated.
*2 SUB VOL + has a tactile dot.
Note
• If the system is turned off and the indicators on
the cradle/DSP master unit are off, remote
commander operation is not possible. To
activate the system again, press the SOURCE/
OFF button on the cradle, and make sure that
the indicators on the cradle/DSP master unit
are lit.
1
page 9
2
7