Hach TL2360 Manual Básico Del Usuario página 20

Option Description
Operator ID Selects only the data that was stored with a specific operator ID.
Sample ID Selects only the data from the Reading Log that was stored with a specific
sample ID.
6.4.2 Send data to a connected device
The instrument can send data to a USB memory device or Seiko DPU-S445 printer. For best results,
use only USB 2.0 memory devices. The instrument makes a logger folder on the device and saves
the data as a .bmp, .csv or .xml file.
1. Connect a USB memory device or cable to a USB port on the instrument.
2. Connect the other end of the cable to the printer, if applicable.
3. Go to Setup>Peripherals. The connection status shows Connected. If the status shows Not
Connected, make sure to use the recommended devices.
4. Push Data Log and select the applicable log.
5. To send only some of the data, use the filter settings or select a single data point. Refer to
the recorded data
6. Push Options>Send Data Log. Select single data point, filtered data or all data. Push OK.
The instrument sends the selected data to the connected devices.
6.4.3 Delete data from the data log
The instrument automatically deletes the oldest data record when the data log is full. The user can
also delete data manually. Make sure to save the data to an external device, then delete the data in
the data log.
1. Push Data Log and select the applicable log.
2. To delete only some of the data, use the filter settings. Refer to
on page 19.
3. To delete the data, push Options>Delete Data. Select single data point, filtered data or all data.
Push OK.
The instrument deletes the selected data from the data log.
Section 7 Maintenance
Multiple hazards. Only qualified personnel must conduct the tasks described in this
section of the document.
7.1 Clean spills
Chemical exposure hazard. Dispose of chemicals and wastes in accordance with local,
regional and national regulations.
1. Obey all facility safety protocols for spill control.
2. Discard the waste according to applicable regulations.
7.2 Clean the instrument
Clean the exterior of the instrument with a moist cloth, and then wipe the instrument dry.
20 English
on page 19.
C A U T I O N
C A U T I O N
Show the recorded data
Show