Switching On; Temperature Control - Techne Hybrigene Manual Del Usuario

Switching On

Once your Hybrigene is connected to a power supply, switch it on using the power switch
next to the power inlet socket on the rear panel.

Temperature Control

Actual
Temperature
Press the 'P' button on the controller and the set temperature will be displayed.
To increase the set temperature press the up arrow button.
To decrease the set temperature press the down arrow button.
If no key is pressed for 5 seconds the display will return to the measured temperature and
the unit will go to the new set temperature.
The Heater Indicator will be lit while the heater is on.
The set temperature can be checked at any time by pressing the 'P' button.
Speed control
Fully anticlockwise the speed control knob switches the rotation of the
tubes off
It then increases the speed clockwise and decreases the speed
anticlockwise in steps of approximately 4 rpm. Switch the knob until you
have the speed you require.
Speed control knob
Front panel of the Hybrigene
Heater indicator
TDH
out 2 out 1
Temperature
Set button
Controller Display
H y b r i g e n e O P E R A T O R ' S M A N U A L
Increase
button
!
!
P
Decrease
button
Controller
15