Troubleshooting - Imetec ZEROCALC PRO 2200 Instrucciones Para El Uso

CLEANING
IMPORTANT! Ensure the plug of the appliance is
EN disconnected from the socket and the plate has
cooled down completely before cleaning the iron.
Any starch deposits or residue on the surface of the plate can be removed with a damp cloth
and non-abrasive liquid detergent.
Avoid scratching the plate with steel wool or metal objects.
The plastic parts can be cleaned with a damp cloth and then wiped with a dry cloth.
This chapter describes the most common problems that can arise using the appliance. If
the problems cannot be solved with the information below, please contact the Authorised
Assistance Centre.
Problem
The plate (10)
remains cold or
does not heat up.
The plate
temperature LED
(1) goes on and
off.
Only a little steam
or none at all is
dispensed.
16

TROUBLESHOOTING

Possible cause
There is no power supply.
Normal procedure.
The steam selector (5) is
set to 0.
There is not enough water
in the reservoir (11).
Solution
Verify whether the plug (13) is
inserted correctly or try inserting it in
another socket.
Check whether the temperature
adjustment knob (2) is set to the
minimum temperature (Fig. D).
The switching ON and OFF of the
LED indicates the heating phase of
the iron. The LED goes off once the
set temperature is reached.
Set the steam selector (5) to the
desired field (Fig. B).
Fill the reservoir (11).