End Of Use; Troubleshooting - Imetec NO STOP VAPOR E9801 Instrucciones Para El Uso

Switch the appliance off by pressing the ON/OFF button (3).
• Disconnect the plug (4) from the socket.
• Wait for the appliance to cool down completely before putting it away. The reservoir (1)
does not have to be emptied.
NOTE:
If the appliance is not to be used for several weeks, remove and empty the water
reservoir (1) completely.
This chapter describes the most common problems that can arise using the appliance. If the
problems cannot be solved with the information below, please contact the Authorised
Assistance Centre.
Problem
The appliance does not turn on.
The plate temperature LED (11)
goes on and off.
Smoke comes out of the
appliance when it is switched on
for the first time.
Impurities come out of the plate
(12).
The appliance does not produce
steam.
The boiler cleaning LED (7)
continues blinking even after it
has been cleaned.
The plate (12) is dirty: there are
impurities or limescale residues.
All manuals and user guides at all-guides.com

END OF USE

TROUBLESHOOTING

Possible cause
The household appliance is not on.
Normal procedure.
This is absolutely normal and is
due to the expansion of the plastic
material.
This is perfectly normal in a new
iron.
The appliance is not on.
The steam button (13) is not being
pressed.
The water in the reservoir (1) has
finished and the no water LED (8)
is on.
The water reservoir (1) is not
positioned correctly on the boiler
and the no water LED (8) is on.
The ECO button (5) was not held
down long enough.
The impurities or chemical
substances found in the water
have deposited on the plate.
You are ironing at a temperature
that is too high.
An excessive amount of limescale
and minerals has accumulated in
the boiler.
Solution
Ensure that the appliance is properly
connected to the socket, that the ON/
OFF button (3) is pressed and the light
is on.
The switching ON and OFF of the LED
(11) indicates the heating phase of the
iron. The LED goes off once the set
temperature is reached.
This no longer occurs after a while.
These particles are completely harmless
and will disappear after the iron is used
a few times.
Press the ON/OFF button (3).
Keep the steam button (13) pressed as
you iron.
Fill the water reservoir (1) (see chapter:
FILLING THE RESERVOIR WHILE
IRONING).
Position the reservoir by making it slide
on the guides until it clicks into position.
Hold the ECO button (5) down until the
LED goes off.
Wait for the plate to cool down and clean
it with a damp cloth.
Wait for the plate to cool down and clean
it with a damp cloth.
Clean the boiler (see the CLEANING
THE BOILER chapter).
EN
15