Mounting Instructions - Bosch Rexroth SE311 Manual Del Usuario

3 609 929 983/1.0 | SE311

4 Mounting Instructions

Unqualified repairs or operations on the
hardware or software or the failure to observe
the warnings in these instructions or
warnings placed on the product itself could
lead to personal injury or damage to
equipment.
Qualified personnel are:
– Project personnel , familiar with the safety
regulations of automation systems and
electrical engineering.
– Operators , instructed in the use of the
equipment and having knowledge of the
relevant operational parts of this
documentation.
– Commissioning personnel , authorized
to set electric circuits and machines/
systems into operation, ground and mark
them, according to the accepted rules of
safety and current technology.
Repairs and replacement of parts carried out
by the user are his own responsibility. After
repairing or replacing parts, all prescribed
functional and safety checks must be carried
out.
Electric Drives and Controls | Bosch Rexroth AG 11 /40
4 Mounting Instructions
The tightening controller is to be inserted into
the slots provided in the system boxes or in
the BT300 card rack.
3 Min
Make sure that the tightening controller is
completely inserted.
The front knurled bolts must be tightened.
Make sure that the front panel fits tightly to
the BT 300 or system box by tightening the
knurled bolts.
Before the tightening
controller is inserted,
the system boxes or
BT300 card rack must
be switched to neutral
and a discharging time
of ≥ 3 minutes must be
taken into account.
Otherwise the time
until the next restart is
approx. 30 seconds.