Troubleshooting Guide - Kärcher CV 30/1 Manual De Instrucciones

Cleaning the roller brush
1. Remove the brush cover if necessary:
Use a coin to turn the rotary lock by 90°
and remove the brush cover.
2. Cut off hair and threads wound onto the
roller brush using scissors and remove
them.
Changing the filter bag
1. Unlock and remove the filter cover.
2. Turn the filter bag lock to the right to un-
lock. Close the filter bag, remove and
dispose of it.
3. Insert a new filter bag and turn the filter
bag lock to the left to lock.
4. Fit and lock the filter cover.
Replacing the exhaust filter
1. Unlock and remove the filter cover.
2. Push the filter casing locking mecha-
nism upwards and remove the filter cas-
ing.
3. Remove the exhaust filter from the filter
casing.
4. Insert a new exhaust filter in the filter
casing.
5. Insert the filter casing and latch it into
place.
6. Fit and lock the filter cover.
Replacing the motor protection filter
1. Unlock and remove the filter cover.
2. Press the motor protection filter lock up-
wards. Remove the old motor protection
filter and dispose of it.
3. Fit and lock the new motor protection fil-
ter.
4. Fit and lock the filter cover.
Replacing the roller brush
Please make sure that the bracket is al-
ways completely opened during installa-
tion.
1. Fold the bracket on the side section fully
upwards and remove the side section.
2. Pull out the old roller brush and dispose
of it.
3. Insert a new roller brush in the side sec-
tion.
4. Push the side section together with the
roller brush into the device.
5. Fold the bracket fully downwards to lock
the side section.

Troubleshooting guide

Remove the blockage
Suction pipe/suction hose
English 15