Operation; Transport; Storage; Care And Service - Kärcher CV 30/1 Manual De Instrucciones

Operation

Adjusting the height of the handle
The height of the handle is adjustable.
See page 4 for illustrations
1. Open the handle adjustment.
2. Move the handle up or down to set the
desired height.
3. Close the handle adjustment.
Switching on the device
1. Connect the mains plug.
2. Switch on the device at the main switch.
Roller brush operation
1. Adjust the fibre height using the fibre
height selection knob on the brush head.
2. Perform cleaning.
Using accessories
Vacuum with the crevice nozzle and cush-
ion nozzle.
See page 4 for illustrations
1. Pull the suction pipe out of the mount.
2. Remove the desired accessory from the
storage compartment and plug it onto
the suction pipe.
3. Perform cleaning.
Suction pipe operation
ATTENTION
Risk of damage!
Do not set the brush head with the rotating
roller to the deep-pile carpet setting when
vacuuming using the suction hose. The
carpet could be damaged or destroyed if
the rotating brush remains in the same po-
sition for a longer period of time.
Switching off the device
1. Switch off the device at the main switch.
2. Pull out the mains plug.
14
The mains cable can be stored on the device.
See page 4 for illustrations
1. Wind the mains power cable onto the
winding aid.
2. Wind the mains cable around the cable
hook and handle.
3. To remove the cable, open the cable hook
and remove the cable from the handle.
CAUTION
Failure to observe the weight
Risk of injury and damage
Be aware of the weight of the device during
transportation.
1. Wind the mains cable around the cable

storage.

2. Carry the device by the carrying handle.
3. When transporting the device in vehi-
cles, secure it to prevent it from slipping
or overturning in accordance with the re-
spective valid guidelines.
CAUTION
Failure to observe the weight
Risk of injury and damage
Be aware of the weight of the device during
storage.
The device may only be operated indoors.

Care and service

Maintenance intervals
ATTENTION
Risk of damage
Please adhere to the specified mainte-
nance intervals in order to prevent damage
to the device.
1. Clean the roller brush.
1. Check the roller brush for wear.
Note
The degree of wear can be determined by
comparing the differently coloured indicator
tufts. Replace the roller brush when the
black bristles are the same height as the
red bristles.
English
Cable storage

Transport

Storage
Daily
Weekly