Troubleshooting - Kärcher DS 5.800 Manual Del Usuario

Troubleshooting

You can rectify minor faults yourself with the help of the
following overview.
If in doubt, please consult the authorized customer ser-
vice.
Appliance does not vacuum
Power supply is interrupted
 Remove the mains plug, check the connecting ca-
ble and the mains plug for damage.
Weak/diminishing suction power
Forgot the baffle plate or not inserted correctly
 Reinsert the baffle plate correctly.
(see: FILLING THE WATER FILTER RESER
VOIR)
Intermediate filter missing or not inserted correctly
 Check the intermediate filter.
Intermediate filter is dirty
 Wash the filter, install new intermediate filter if re-
quired. (see: CARE, MAINTENANCE)
Intermediate filter is wet
 Let the intermediate filter dry or install new dry filter.
(see: CARE, MAINTENANCE)
Strong foam generation in the water filter reservoir
 Replace the water and add 1 to 2 capfuls of Foam-
Stop. Check the intermediate filter for moisture. If
necessary, clean the damp filter under running wa-
ter and allow it to dry afterwards or install new filter.
Too little or too much water in the water filter
reservoir
 Check the MIN / MAX marks on the reservoir.
HEPA filter is soiled
 Replace the HEPA filter.
(see: CARE, MAINTENANCE)
Accessory is blocked
 Remove the blockage.
(see: CARE, MAINTENANCE)
False air slide at the handle is open
 Close the false air slide.
(see: WORKING WITH THE FLOOR NOZZLE)
Appliance flap does not close
The cover of the water filter is not properly installed
 Properly install the cover of the water filter container.
The water filter is not properly installed
 Remove the water filter and correctly insert it into
the appliance.
(see: FILLING THE WATER FILTER RESERVOIR)
16
– 10
EN